iPhone XS Max display replacement


Hello everyone, today I show you how to disassemble
iPhone XS Max and replace display module. To disassemble the iPhone XS Max you need
the following tools Screwdriver set
Tweezers Opening plastic tool
Plastic mediator Suction cup for removing display
In the description of this video, I left links to the necessary tools and parts for replacement
Before disassembling, turn off the iPhone and remove the sim card tray. Unscrew two screws near the lightning port. Display glued around perimeter of iPhone XS Max and
we need to heat the surface of iPhone for open it. Apply the suction cup to the bottom edge of
the display and pull up on the ring. Next, push the plastic mediator between the
display and iPhone case. From this position, evenly and slowly, open
the display around the perimeter of iPhone. The iPhone case opens like a book; the display
opens to the right side. Next, using a Tri-Wing screwdriver, unscrew
the 4 screws and remove the metal panel. Disconnect the battery cable from the mainboard. Unscrew the 3 screws and remove the second
metal panel. Disconnect 2 cables of the display and the
sensor panel cable from the mainboard. Now you can remove the display. To replace the display module on iPhone XS Max, you need to remove the panel with speaker and sensors. Unscrew 3 screws using a Tri-Wing screwdriver. Using hair dryers, heat the front side of
the display where located the sensor panel. Carefully separate the sensors from the display
housing. If the light sensor cannot be remove with
light movements to the sides, again heat the front side of the display. If this sensor is damage or replace, the Face
ID will be lost, so special care is required not to damage one of these components during
removal and replacement of the display. Before buying a new display module, pay attention
to the presence of the holders for the camera and sensors. In the description of this video, I left links
where you can buy new display. Install the proximity sensor and light sensor. Install the speaker and fasten the 3 screws. The display module assembled, now we can install
the display and test how everything works before final assembly with gluing the iPhone
case. Connect 3 cables from the display module and
only after that connect the battery cable to the mainboard. Turn on the iPhone and install the sim card. Let’s test how everything works, and if
it works well, let’s go to the final assembly with gluing the iPhone case. Remove the old adhesive tape from the iPhone
case. After, using medicine alcohol wipe the surface
of iPhone case and display module. Now, take new adhesive tape and apply to the
case. With this tape, you save waterproof resistance
of the iPhone. I left link where you can buy this adhesive
tape in description. You can install the display without adhesive
tape, but you will lose waterproof resistance. Connect 3 cables from the display to mainboard. Set metal panel and fasten 3 screws. After, connect battery cable to the mainboard. Set metal panel and fasten 4 screws. Now, close the iPhone case … and press down
the display around the perimeter. Fasten the two screws near the lightning port. Now you can turn on the iPhone XS Max and
use it.

9 Comments

Add a Comment

Your email address will not be published. Required fields are marked *